Tranny shift points
#1
Tranny shift points
Last week i replaced the trans filter and gasket on my 5 speed auto. Since then i believe first gear is being held longer than it used to. (it may not be i just have been listening to it shifting more than i used to) Does any one have the stock shift points for my trans?
#2
Actually, I'm in the middle of updating my tunes. Tonight when I'm working on them.. I'll let you know what my stock 06FX4 settings are.
btw.. if you have a OBD2 scanner that can see the tranny gear? You can see when the PCM commands the shift.
It's all a balance of TPS and speed. So.. to say something like.. 18mph for the 1-3 shift (skip shift for the 5speeds) is really dependant on what the TPS is. (throttle position)
Rich
btw.. if you have a OBD2 scanner that can see the tranny gear? You can see when the PCM commands the shift.
It's all a balance of TPS and speed. So.. to say something like.. 18mph for the 1-3 shift (skip shift for the 5speeds) is really dependant on what the TPS is. (throttle position)
Rich
#4
I'm not sure about a 98 ranger. But on my 06 w/5speed that could be done in the tune.
Really.. it's all based on three things as far as a tune goes. Vehicle speed, throttle position, and the math curves in the tune.
Tonight I'll post up some pics of what they look like in stock form.
Rich
Really.. it's all based on three things as far as a tune goes. Vehicle speed, throttle position, and the math curves in the tune.
Tonight I'll post up some pics of what they look like in stock form.
Rich
#6
#7
Just and FYI.
Rich
Thread
Thread Starter
Forum
Replies
Last Post
Enduro
General Ford Ranger Discussion
17
03-16-2024 04:36 PM
dschmitz
Drivetrain Tech
1
04-30-2023 09:05 AM
Topdog2007
General Ford Ranger Discussion
1
03-18-2011 09:38 PM