was wondering who had any pics at all.....its the setup i will be running and like to get a general idea of where the sticks will come through the floor

 

your running a doubler?

 

no, im running a twin stick 205

 

I've got a '78 F150 frame with an np435 and a 205 on it. No motor or bellhousing though. I don't know if this helps.

 

actually, ur in NJ right, whats the odds of the shifter linkage being intact on that 205 case, and would u be willing to let that go, and also, what size bed did the truck have, im lookin for a set of driveshafts if there in the truck

 

I'm in PA, just north of Reading. It's not twin-sticks, if that is what you were hoping. But the stock linkage is all intact. The truck was a short bed, I think. I'm not sure. I cut the body off of the truck and now its just the frame, suspension and axles. If the linkage is what you want, I'll sell it to you.

These are the most recent pictures I have of it. I could take measurements if that helps more.

(Scroll Towards the bottom)

Build Thread

 

na, single stick would be fine, for my purposes i really dont need a twin stick, but if i had to i had to lol, and the driveshafts arent still on that truck are they, shoot me a price for the shifter linkage. and the driveshafts if u still have them

and if u could measure up the wheelbase of that truck lemme know, center of wheel to center of wheel, that is if ur not using the drive shafts

 

Driveshafts are still on the truck. I'm not planning on using them, but I won't know for sure for a couple of days. I'm gonna be real busy til Saturday, so I'll take care of it then. I should have some numbers for you Saturday night.

 

any update on them shaft lengths

 

Twin Stick 205? never seen one of those.

 

its realtivly common, comes in handy when i need to control the front and rear differently

 

What'd they come in?

 

they didnt come in anything like that, as u can see in the picture, they have seperate shift rods that control the front and rear outputs on the transmission, so as in the first pic that is the simplest setup for a twin stick 205 u can run, for when u was 4low front wheel drive only

 

Thanks man...yea i've seen those conversions before...just was confused. Also...nice driveshaft brake. That's awesome.

 

teh driveshaft brake is not mine, but i will be running something similar on the pinion for a little bit of extra breaking power