Audio & Video Tech General discussion of audio and video for the Ford Ranger.

sub and amp help QUICK

Thread Tools
 
Search this Thread
 
Old Mar 15, 2007
  #1  
timpat92855's Avatar
Thread Starter
|
Member
iTrader: (1)
Joined: Nov 2006
Posts: 1,067
Likes: 3
From: Lousiville, MS
Icon8 sub and amp help QUICK

I had my amp and sub out of my truck t he past few days cuz i needed to use my cab and i went to put it in tonight and its not doing right...every time i change the song it rumbles and sratches...and on my HU i can turn my sub on and off but when its off its still on and never done it before??? plus my amp is only pushing maybe half the power it did...i checked my grounds and even checked wiring on the speaker and everything, its all still the same? whats going on? anyone have any clue its really got me pissed off, oh and its a kicker cvr 10 and a kicker 200x2 amp
 
Reply
Old Mar 15, 2007
  #2  
timpat92855's Avatar
Thread Starter
|
Member
iTrader: (1)
Joined: Nov 2006
Posts: 1,067
Likes: 3
From: Lousiville, MS
and now it plays fine with only one rca hooked up..if the other is connected the amp goes into protection mode, it still does the rumbling though...
 
Reply
Old Mar 15, 2007
  #3  
03bamaGT's Avatar
Member
Joined: Aug 2006
Posts: 1,752
Likes: 0
From: B'ham, AL
RCAs reversed? dont think so b.c. it wouldnt play anything. CHECK YOUR GROUNDS AGAIN.
 
Reply
Old Mar 15, 2007
  #4  
timpat92855's Avatar
Thread Starter
|
Member
iTrader: (1)
Joined: Nov 2006
Posts: 1,067
Likes: 3
From: Lousiville, MS
i have the amp grounded to my passenger seat bolt with the paint grinded off, is there a better place to ground it at? i played with the rcas and it does it either way, even on the output side of the amp
 
Reply
Old Mar 15, 2007
  #5  
03bamaGT's Avatar
Member
Joined: Aug 2006
Posts: 1,752
Likes: 0
From: B'ham, AL
There are but it wont matter thats where mine is. Ill have to think about it.
 
Reply
Old Mar 15, 2007
  #6  
timpat92855's Avatar
Thread Starter
|
Member
iTrader: (1)
Joined: Nov 2006
Posts: 1,067
Likes: 3
From: Lousiville, MS
LOL, got me baffled...
 
Reply
Old Mar 16, 2007
  #7  
Bhavesh's Avatar
Member
Joined: Oct 2006
Posts: 507
Likes: 2
From: City, State
amp might be fried
 
Reply
Old Mar 16, 2007
  #8  
timpat92855's Avatar
Thread Starter
|
Member
iTrader: (1)
Joined: Nov 2006
Posts: 1,067
Likes: 3
From: Lousiville, MS
it pushes full power with one rca though....when the other is hooked it goes in and outta protection mode, its really bothering me
 
Reply
Old Mar 16, 2007
  #9  
4x4 EDGE's Avatar
Member
Joined: Mar 2007
Posts: 246
Likes: 0
From: Lyons, NY
Check the fuses on the amp. The amp I have running my midranges has two fuses and one was blown and it did the same thing you're describing.
 
Reply
Old Mar 16, 2007
  #10  
timpat92855's Avatar
Thread Starter
|
Member
iTrader: (1)
Joined: Nov 2006
Posts: 1,067
Likes: 3
From: Lousiville, MS
mine is only one fuse and its a 30amp, and its fine i just went and checked
 
Reply
Old Mar 16, 2007
  #11  
Marcaronio's Avatar
Member
iTrader: (1)
Joined: Oct 2006
Posts: 560
Likes: 1
From: Spring Hill, FL
1. Check to see that you have power wire hooked up to power and remote hooked up to remote and not the other way around.
2. If your wires are run underneath the carpet check to see that one of them didn't get smashed by whatever you put in your cab.
 
Reply
Old Mar 16, 2007
  #12  
timpat92855's Avatar
Thread Starter
|
Member
iTrader: (1)
Joined: Nov 2006
Posts: 1,067
Likes: 3
From: Lousiville, MS
they are under my carpet, and wires are ran the right way, i went threw that last night lol, i will go pull them out from under the carpet and check, i would not of thought of that one
 
Reply
Old Mar 16, 2007
  #13  
bamaboy's Avatar
Member
Joined: Jun 2005
Posts: 531
Likes: 0
From: ALabama
make sure you didnt rip/tear/etc the rca wire

your getting noise in the system somewhere, all you did was rehook up the amp, not add anythings?
 
Reply
Old Mar 16, 2007
  #14  
timpat92855's Avatar
Thread Starter
|
Member
iTrader: (1)
Joined: Nov 2006
Posts: 1,067
Likes: 3
From: Lousiville, MS
yea all i did was put everything back in, its the same stuff i had for 3 months now and never had a problem out of it til now, the rcas are fine, i just pulled them outta the truck and looked, besides being cheap walmart ones they are fine
 
Reply
Old Mar 16, 2007
  #15  
Marcaronio's Avatar
Member
iTrader: (1)
Joined: Oct 2006
Posts: 560
Likes: 1
From: Spring Hill, FL
It sounds to me like a bad head unit. I would say bad amp, however, the amp functions fine until you switch stations or songs. Is the head unit a cheap walmart one as well?
 
Reply
Old Mar 16, 2007
  #16  
timpat92855's Avatar
Thread Starter
|
Member
iTrader: (1)
Joined: Nov 2006
Posts: 1,067
Likes: 3
From: Lousiville, MS
its a pioneer DEH-3900 the 06 model, i had it for about 7 months, its only problem is it dont spit the cds out all the, never had a problem besides that, but im starting to think it is the problem, it does it on all 3 sets of pre amps too,
 
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
ranger024x4
OLD - Interior, Exterior, Electrical, & Misc.
3
Dec 17, 2010 12:39 PM
pushdeck
OLD - Interior, Exterior, Electrical, & Misc.
1
May 2, 2010 10:39 AM
crucialcolin
Audio & Video Tech
13
Jun 21, 2008 09:13 PM
Gearhead61
Audio & Video Tech
7
Oct 4, 2006 12:30 AM




All times are GMT -6. The time now is 03:27 PM.