where to run wire???
#1
where to run wire???
im putting my system into the ranger now its an 04 supercab vinyl not carpet.
Sofar from what ive run into the 4awg and my rca's/ speaker wire for the 2 amps are not gonna fit running along by the door sills. And it seems like my only 3 other options is through the center under the vinyl which i think imo would look retarded cause it would bulge out
along the top by the roof and back down the side to the back or under the truck hugging the frame n crap, which would be hecka retarded.
what did everyone else do that doesn't have carpet and no room under the side rail thing-O???
Sofar from what ive run into the 4awg and my rca's/ speaker wire for the 2 amps are not gonna fit running along by the door sills. And it seems like my only 3 other options is through the center under the vinyl which i think imo would look retarded cause it would bulge out
along the top by the roof and back down the side to the back or under the truck hugging the frame n crap, which would be hecka retarded.
what did everyone else do that doesn't have carpet and no room under the side rail thing-O???
#3
I forget where I ran it, but it was under the vinyl carpet. If I can run 0 gauge wire and forget where I ran it, then you should be able to put 4 AWG under there without noticing. It's very easy if you take out the sill and the seat. Just be sure not to run anything close to the seat rails, as they may pinch the wire.
#5
#8
well i thought it would bubble the vinyl up but i was wrong i jst spread all my wires like crazy across the floor no probs cant even tell or ermember what is where, all hooked up and the install is damn hott n clean cant wait to make fiberglass enclosures built into the side cubby things where the jumps seats mount
Thread
Thread Starter
Forum
Replies
Last Post