I am needing to replace my engine mounts and trans mount in my truck,

2001 Ranger XLT, 2.3L auto, 2wd/rwd.

I am not going to pay money at advance for shitty mounts that everyone complains about.

Does anyone have the Ford part numbers by chance for the left and right side motor mounts and the transmission mount?


Thanks much,
-Nigel

 

I believe I found them:

Might help someone in the future.

Thanks,
-Nigel

 

FYI, I had bought some hydro mounts and a trans mount from rock auto and they seem to be holding up well. My truck idles nice and smooth now, my old ones were thrashed to the point where it felt like the motor was flexing when I accelerated.

Also part of my rough idle was from my t-belt slipped a or a couple of teeth.

 

Ranger 2004 3.0 Getting code 305 & 316 I have replaced wires, plugs, cam sensor, crank sensor, both oxygen sensors and coil pack, as well as fuel filter. The compression test on #5 is good, what’s next to check. The fuel injector?
Thanks for your help in advance

 

Tsc,
Please start your own thread.

This thread is about motor mounts for a 2.3.


Go here and click on new thread
https://www.ranger-forums.com/2-9l-3-0l-v6-tech-32/