Front Driveshaft Question
#1
Join Date: Jul 2007
Location: Anderson, SC
Posts: 704
Likes: 0
Received 0 Likes
on
0 Posts
Front Driveshaft Question
I need to change my clutch but this is the first time i've messed with the front driveshaft on a newer model. Is it best to disconnect it from the front or at the transfer case ? If from the TC, is all I have to do is take out of the bolts ?
Sorry for not being around much in the last few months but the academy had me tied up every day. Feels good to be back though.
Sorry for not being around much in the last few months but the academy had me tied up every day. Feels good to be back though.
#2
I've only ever taken my stock out out from the front first, then the back. The six bolts at the T/C end of it are all that holds it on, you should be good to go. It might be just as easy to to do the front as well, it's only 4 bolts and you're done. That way the whole thing is out of the way. Just make sure you mark the shaft, yoke and T/C so you get everything back together the same way it came apart!
#5
Thread
Thread Starter
Forum
Replies
Last Post
Want to Trade: My Aluminum Driveshaft for your Steel Driveshaft - WA
wellcom2knoxvile
OLD - Engine & Drivetrain
2
08-23-2010 07:17 AM
chevyslayer925
General Technical & Electrical
11
12-28-2008 02:47 PM
Grimach07
General Ford Ranger Discussion
8
08-07-2006 08:53 PM