Anyone did a MR. GASKET floor shifter yet?
Thread Starter
|
Member
Joined: Oct 2018
Posts: 45
Likes: 0
From: AUBURN, WA
Anyone did a MR. GASKET floor shifter yet?
Tying up the last few strings on my A4 swap and had some questions has anyome done a mr. Gasket floor shifter BEFORE...
If so I had questions about the distance from the dash board between 88-90 is a typical install area.
Photos would help a lot thanks...
Transmission is installed just need to bolt the converter up, starter and put the last nuts in the axle half shaft.
If so I had questions about the distance from the dash board between 88-90 is a typical install area.
Photos would help a lot thanks...
Transmission is installed just need to bolt the converter up, starter and put the last nuts in the axle half shaft.
Last edited by 90sboyRangerDanger; Dec 28, 2018 at 09:50 PM.
Thread
Thread Starter
Forum
Replies
Last Post
