Front End Noise (clunking)
well i believe its my front cv's its sounding like its falling apart......iam started to get tired of this if it isnt one thing its another
|
are the cv boots intact?
|
Originally Posted by gatorblue92
are the cv boots intact?
|
|
take the wheel off make sure your CV boot is good..no grease thrown anywhere..
make sure your caliper bolts are tight..and your caliper isnt frozen shut.. |
Originally Posted by HighRollerII
take the wheel off make sure your CV boot is good..no grease thrown anywhere..
make sure your caliper bolts are tight..and your caliper isnt frozen shut.. |
|
|
um you dont have a limited slip in the front... therefor both of the front wheels are not going to spin...
i dont see and issue or hear anyhting? |
maybe a wheelbearing?
|
Originally Posted by zabeard
um you dont have a limited slip in the front... therefor both of the front wheels are not going to spin...
i dont see and issue or hear anyhting? |
idk not necessarily...
|
Originally Posted by zabeard
idk not necessarily...
|
haha man you have an OPEN front diff...only a pinion and some gears that left front wont spin..
BUT with no weight on the bastard it should spin backwards..id say grab the front CV and just pul on er..does it move? rattle? anything? and id she ahs lots of play id be rippen the diff out and takin the cover off..might have something wrong in the pionion or mini axle ID ALSO be careful doing it but try and spin it while the rest are..it if grabs and goes backwards well it should be ok.. Spin the good one forwards when locked in 4x4 and the engine off..then run over to the other side see if its going backwards |
I had the same problem, turned out to be the universal. Replaced that and it started clunking worse. Turns out that when I put them back together, rotated the one shaft a 1/4 turn and threw it out of balance.
|
Originally Posted by zabeard
um you dont have a limited slip in the front... therefor both of the front wheels are not going to spin...
i dont see and issue or hear anyhting? |
it something suspension wise then.
ball joints? CVs shouldnt clunk, maybe if you hammered on it while the wheel was turned full lock. then they would pop im thinking ball joints maybe inner tierods. |
Originally Posted by zabeard
it something suspension wise then.
ball joints? CVs shouldnt clunk, maybe if you hammered on it while the wheel was turned full lock. then they would pop im thinking ball joints maybe inner tierods. i had all ball joints/wheel bearings checked and all are good...... |
can you feel it in the floor? and does it only do it when drving slow? or at all speeds?
|
grab the front driveshaft and wiggle it around see if it has slop in it. same with the cvs.
were you even in 4wd in the parking lot? |
Originally Posted by Sonic_03
can you feel it in the floor? and does it only do it when drving slow? or at all speeds?
|
Originally Posted by zabeard
grab the front driveshaft and wiggle it around see if it has slop in it. same with the cvs.
were you even in 4wd in the parking lot?
Originally Posted by zabeard
grab the front driveshaft and wiggle it around see if it has slop in it. same with the cvs.
|
Well the driveshaft makes alot of noise when you wiggle it and that may be what iam hearing........the front cv's are nice and firm...make a little noise but not much.....
|
Wow i dont know man i would say shake down your front end real good see if u hear anything from upper balljoints lowers ones, but also see if theres any play in it. Good luck
|
|
All times are GMT -6. The time now is 12:21 AM. |
© 2024 MH Sub I, LLC dba Internet Brands