I have a truck with only 93xxx on it and i put a brand new clutch in and then found out after that the guy who did it didnt change out the fluid so i replace all the fluid at the master cylinder and replaced the master cylinder and still it wont go into to gear its like the clutch is only getting have the engagement it should and i just dont see what else to replace to make this shift properly and its really pissing me off but cant find a solution any suggestions i could really use the help. It doesnt grind it just wont go in hard to explain and its anytime i shift with any gear its all the same

 

The synchro gears in the TK5 tranny might be going out. Similar problemn with my 85 Ranger. Try when slowing to quickly downshift through the gears and before the shaft stops spinning make it into first and see if that makes it easier until you're able to get it fixed to pick up a junkyard trans or rebuild yours. Gonna be expensive to take to shop even if you just take them the tranny only. Got junk yard one myself then try to rebulid the other myself as kits are relatively inexpensive. Good Luck.