WTB: Trans Cooler Bolt: MN
#5
If you look at the trans cooler there at 3 bolts holding it to the header panel. One below where the horn is and 2 lower down. Its the only 3 bolts that are attached to the cooler. It has a 5/16"/8 mm head on it.
#6
Why don't you just go to the junkyard and grab them? It would be cheaper gas than getting them sent to you in the mail. Is this not obvious? And the junkyard wont even charge you for them, **** id just stuff bolts in my pockets cause they dont care.
#7
Yeah the only problem is that John's pulls tranny coolers so the bolts are gone, and U Pull doesnt have anything new enough. Besides Blhde owes me......
#8
LOL.
I will take a look later today at the box of bolts I have. I have stripped the front of this explorer down, and sold some of it.
I will take a look later today at the box of bolts I have. I have stripped the front of this explorer down, and sold some of it.
#9
ok sweet. Its a screw with a hex head on it. Only about 3/4" long and it has a washer attached to it.
Thread
Thread Starter
Forum
Replies
Last Post