Looking for input on aftermarket fender flares-(Bushwacker, EGR,...). After the wheel spacer install, I think I'm going to need some.
No OEM-I don't want to be drilling holes in he side of my truck.
How's the fit? Drilling required? Pics?
I prefer not to drill if at all possible.
Thanks
MikeR

 

free bump

 

I got the bushwacker OE spec ones on my truck. The front went on with no problems. But with having the stepside bed, the fender flares pushed out on top of the fender. I drilled two holes on the top (through flare and fiberglass) and installed a small push pin to retain them and make sure the don't push back out. But with a regular bed, they should bolt up just fine with predrilled fender holes. Well my truck had predrilled ones, not sure if yours does. Here is some pictures.

Front


Back

 

If you don't mind me asking, how much did those run you?

 

I got the extend-a-fender EGR ones for $150 on CL.

Ford Ranger Forum - The Ultimate Ford Ranger Resource - Masteratarms93's Album: The truck as of Fall 2010 - Picture
Ford Ranger Forum - The Ultimate Ford Ranger Resource - Masteratarms93's Album: The truck as of Fall 2010 - Picture
Ford Ranger Forum - The Ultimate Ford Ranger Resource - Masteratarms93's Album: The truck as of Fall 2010 - Picture

Comes with clips to pop them on. Took like an hour to get all four on. Also comes with screws and a drill bit if you wanted to do that.

 

I got mine right at $300. Kinda pricey but they fit extremely well except for the back. But that was to be expected b/c of the stepside bed.