Body kit...will it work?
Member
Joined: Jun 2004
Posts: 109
Likes: 0
From: Sacramento, CA
Check out my FTW page @ http://www.ftwtrucks.com/fordman33
and you will see the Razzi Body Kit, and the Xenon front bumper. Overall the Mazdas and the Rangers are the same body. The biggest difference is in the front (bumper, grille) and the rear taillight setup. Other than that things are the same underneath and on the body.
As for the Extreme Dimensions....that's a diff story, at least where the kit molds into the cab area. I don't know about the Mazdas, but the Ranger Regular cabs grew by 3 inches in 98. That body kit says it is for up to 97. I'm sure a quality body shop can use more fiberglass and extend it to fit. But that's up to you and what you want to.
Good luck.
and you will see the Razzi Body Kit, and the Xenon front bumper. Overall the Mazdas and the Rangers are the same body. The biggest difference is in the front (bumper, grille) and the rear taillight setup. Other than that things are the same underneath and on the body.
As for the Extreme Dimensions....that's a diff story, at least where the kit molds into the cab area. I don't know about the Mazdas, but the Ranger Regular cabs grew by 3 inches in 98. That body kit says it is for up to 97. I'm sure a quality body shop can use more fiberglass and extend it to fit. But that's up to you and what you want to.
Good luck.
Thread Starter
|
Member
Joined: Nov 2004
Posts: 2,664
Likes: 1
From: Danville, VA
cuz i can...
the trucks at that height where it could go either way.....up would cost more money and honestly i think it would look like ***....but lowered it relatively cheaper, i can gain some cool points for looks/handling....and i'd be one of the first lowered mazda b4k's....
the trucks at that height where it could go either way.....up would cost more money and honestly i think it would look like ***....but lowered it relatively cheaper, i can gain some cool points for looks/handling....and i'd be one of the first lowered mazda b4k's....
Member
Joined: Jun 2004
Posts: 435
Likes: 0
From: Poteau, Oklahoma
Heh only thing I can say is be careful and watch all your 4x4 hardware. Looks good anyway though.
Brent, I say you go the route Scotty went and do the 04 valance conversion. It looks sssoooo good and will really make the mazda front end look awesome.
Brent, I say you go the route Scotty went and do the 04 valance conversion. It looks sssoooo good and will really make the mazda front end look awesome.
I wasnt really paying attention to time but it was 3hr at the most, a little exageration... The first side took the longest because i was sorta experimenting but after the experimentation, the second side went in like 45 min tops
Originally Posted by detroitmuscle36
why the hell did you lower a 4x4?
Rangers look stupid when they are lowered anyway.
