another LED mirror question

Reply Subscribe

Thread Tools

Search this Thread

Apr 9, 2007

HighRollerII

Thread Starter

RF Veteran

iTrader: (4)

Joined: Jun 2004

Posts: 10,073

Likes: 4

From: Charleston, SC

another LED mirror question

I got around to wiring them up yesterday..hooked into the wires the papers said too and it works with the blinkers but also with the brakes?!?

it supposed to do that?

Apr 9, 2007

zabeard

who?

iTrader: (8)

Joined: Nov 2004

Posts: 26,044

Likes: 10

From: IN

the wire colors that they have in the book are not right, you need to hunt them down yourself.

I know they are down by the kick panel

Apr 9, 2007

greygooseranger

Member

Joined: Apr 2006

Posts: 3,297

Likes: 1

From: SE Michigan

I think one is white with blue stripe and green with white stripe, Oh green is pass. and white is driver. There is more than one green with white so make sure that you get the green one that is close to the white one, they are both for the blinks...... In mine, which is an 04, it was on the top left of the bundle (after unpluging it)

Apr 9, 2007

94greenmachine

Member

Joined: Aug 2006

Posts: 554

Likes: 1

From: Virginia Beach, VA

dually noted. Thinking about the conversion myself, if i can find the brackets to mount them.

Apr 9, 2007

V8 Level II

RF Veteran

iTrader: (4)

Joined: Nov 2004

Posts: 7,910

Likes: 27

From: Michigan

Quote:

Originally Posted by HighRollerII

I got around to wiring them up yesterday..hooked into the wires the papers said too and it works with the blinkers but also with the brakes?!?

it supposed to do that?

You must have it wired to the rear signals. To avoid having the mirror LEDs light with the brakes on your 2004, you need to wire it to the front signals:

RF: white/light blue
LF: light green/white

The wires are in the harness on the left side of the steering column, then they go through the firewall connector.

Apr 9, 2007

jrpro130

RF Veteran

iTrader: (1)

Joined: Sep 2005

Posts: 5,057

Likes: 1

From: Florida

Quote:

Originally Posted by jrpro130

I just actually figured otu the right wires.

I took off my turning signal bulb to figure it out

The instructions that came w/ it are wrong. It says green/orange and blue/red...which is totally off.

The correct wire colors are drivers side green w/ white stripe and pass side white w/ blue stripe

follow these directions not the directions included.

BTW, I have to re-wire mine b/c for now it is wired w/ a long wire going from each turning signal bulb

That was quoted from my post