CB radio Wiring???
#1
CB radio Wiring???
Hey yall...Havent been on here in months since i have been busy with my website but i finally got around to trying to install my CB. I dont need to wire an antenna since i will only be using the PA for my site promotions.
The Midland CB has:
2 wires coming out of the unit, assuming its a power and ground.
There is a PA input where i plugged in another wire
Then the speaker with 2 wires coming out.
My difficulty is where can i hook the wires up?? I am assuming the PA input wires needs to go to the speaker? So the other 2 wires need to connect to the battery and a ground? How do i connect it to the battery?
Thanks all and its nice being back on here!
The Midland CB has:
2 wires coming out of the unit, assuming its a power and ground.
There is a PA input where i plugged in another wire
Then the speaker with 2 wires coming out.
My difficulty is where can i hook the wires up?? I am assuming the PA input wires needs to go to the speaker? So the other 2 wires need to connect to the battery and a ground? How do i connect it to the battery?
Thanks all and its nice being back on here!
#2
2 wires are power. I ran them to the power distribution box on the drivers side of the engine bay. Grounded it, and powered from the front side of the box where it has a nut you can remove to use a connecter, or washer to make good contact. Its an ''always hot'' spot. Make sure you have an inline fuse in the power line, or you'll smoke the sucker...
The PA will need an 1/8" head phone plug, which you can get at Radio Shack, solder wires to plug and your ready to go...
The PA will need an 1/8" head phone plug, which you can get at Radio Shack, solder wires to plug and your ready to go...
#5
well I hope it is a PA OUTPUT
use a mono miniature plug
inside you will find two spades to solder to
one is for the the signal the other sheild or ground
the two wires from the PA speaker should be soldered to these
use better wire and watch for spots where it could be cut or worn down enroute to your PA speaker mounting location
good luck
use a mono miniature plug
inside you will find two spades to solder to
one is for the the signal the other sheild or ground
the two wires from the PA speaker should be soldered to these
use better wire and watch for spots where it could be cut or worn down enroute to your PA speaker mounting location
good luck
#8
Thread
Thread Starter
Forum
Replies
Last Post
SteelDirigible
OLD - Interior, Exterior, Electrical, & Misc.
0
02-08-2015 03:43 PM
Want to Buy: Wiring harness 04/05 manual wiring harness
Cody.mckinley
OLD - Interior, Exterior, Electrical, & Misc.
0
10-14-2013 02:28 PM
lifted97ranger
General Technical & Electrical
14
04-22-2008 10:02 AM
Chodemnky
General Technical & Electrical
4
04-29-2005 02:30 PM