Fuel INjector specs
#1
Fuel INjector specs
Anyone have the fuel injector dimensions and flow rates on some vehicles?
It can be ford, chevy, toyota, I don't care.
need something close to this but with some more flow!
You asked, here is the info and picture for the current injector. The current unit is 32#, I'm thinking 38-42# is a value you'd want. The connector is a NipponDenso style. If you find a Bosch style connector, you can buy conversion cables that will allow the stock harness to plug into the Bosch EV1 connector.
The style lends itself to something found in a Toyota product (as well as Subrau).
Here is the information we have from the unit:
Length: 2.236” (56.8 mm)
Diameter: 0.550” (14.0 mm)
Nose Diameter: 0.330” (8.4 mm)
Cushion seal diameter: 0.558” (14.2 mm)
Diameter of fuel rail end: 0.411” (10.4 mm)
Diameter of O-ring on fuel rail end: 0.479” (12.2 mm)
Connector: Nippon Denso style
Markings (stamped by connector pins): LICENSE BOSCH
Part Number: 25205Z6 (viewable in the picture that is enclosed).
Flow Rate (measured): 31.6 lbs/hr (333 cc/minute)
Rail Pressure: 43PSI idle, 42PSI injector on
It can be ford, chevy, toyota, I don't care.
need something close to this but with some more flow!
You asked, here is the info and picture for the current injector. The current unit is 32#, I'm thinking 38-42# is a value you'd want. The connector is a NipponDenso style. If you find a Bosch style connector, you can buy conversion cables that will allow the stock harness to plug into the Bosch EV1 connector.
The style lends itself to something found in a Toyota product (as well as Subrau).
Here is the information we have from the unit:
Length: 2.236” (56.8 mm)
Diameter: 0.550” (14.0 mm)
Nose Diameter: 0.330” (8.4 mm)
Cushion seal diameter: 0.558” (14.2 mm)
Diameter of fuel rail end: 0.411” (10.4 mm)
Diameter of O-ring on fuel rail end: 0.479” (12.2 mm)
Connector: Nippon Denso style
Markings (stamped by connector pins): LICENSE BOSCH
Part Number: 25205Z6 (viewable in the picture that is enclosed).
Flow Rate (measured): 31.6 lbs/hr (333 cc/minute)
Rail Pressure: 43PSI idle, 42PSI injector on
Thread
Thread Starter
Forum
Replies
Last Post
n3elz
General Ford Ranger Discussion
16
11-06-2006 02:37 PM