where can i get the shifters im starting my manual tcase swap this weekend and i would like to have the fx4 shifters.

 

dealer

 

LOL ya if you cant find one in the junk yard the dealer last time i checked just the 5-speed arm/ball was over $280 the 4x4 arm and ball prop isnt much better

 

Bob Mc Cormick Ford Incorporated
(570) 546-2222
101 N Main St, Muncy, PA

Dang I'm such a nice guy, I googled your location and came up with the closest place to buy the parts you need.
I was tempted to call and get prices but I don't feel like it.

 

^ lol nice Freddie you google for the closest bank so he can get a loan for the parts? lol

 

Lol give me a sec.

 

1. Muncy Bank and Trust Co
570 546 2211
2 N Main St, Muncy, PA

2. Sovereign Bank
570 546 3121
20 S Main St, Muncy, PA

Ahhh hell with it..
LINK

 

Hahaha....

 

[Threadjack]

Stone, I've got some lvl 2 hooks and a WAAG bar ready to go on, and some Bilsteins here in the VERY near future. Haha Just thought I'd FYI you since ya had to hassle me at the meet EDIT: But I'm holding off. In order to get motivated I am restraining myself and will not allow myself to install those parts til I get my 98 back together... SOOOooo I've been working on the 98 the last few nights haha. Just need to replace the front to rear brakeline, and bleed all the brakes, and I will start installing some parts on the 01 :) You going to drive down to wrestle my stock tow loop bolts?

 

that's kinda what i figured guys and i have sovereign bank so i guess i need to save up to get them or get Hurst shifter which sounds a lot more promising and it makes for shorter shifts so

 

I actually have a FX4 shifter arm for sale right now on ebay

http://cgi.ebay.com/ebaymotors/ws/eB...3AIT&viewitem=

 

wheres the ball?

 

on my hurst shifter arm

 

makes sense lol

 

Take note the FX4 t-case shifter arm will only fit the linkage from the 02 and 03 trucks. If you have an older shift linkage then either the FX4 arm or the shift linkage will need to be modified.

 

Will an FX4 shifter fit my 91 Ranger 4.0l 5-speed? My truck has the electronic T case so no linkage would get in the way.

 

I believe so

nope. me = wrong see below V

 

Not without modification.

 

Correct what bob said. the older R1 the spot it mounts too the bolt is turned 90deg causing all kinda problems..

 

it should fit the tranny shifter but not the tcase

 

both of them will fit neither.. T-case will need to be modified and trans it wont work at all.. unless you cut off the lower part of your and weld it to the level II

 

Thanks guys, I'll set my sights on the Hurst shifter sometime in the future.