I started with a piece of flat 16 ga steel and 2.25" pipe that were laying around the shop. Then cut it to the shape I wanted, and bent the angles using a finger brake.


Welded the pipe in place


Inserted some foam to keep the Mag Lite from rattling and shooting out when I hit the brakes.


Then mounted it to the floor via the drivers seat mount. Here's the finished project.


What do you think?

 

should throw some paint on it, but it looks really good.

 

not bad at all

 

Yeah. I just wanted to try it out and see if I liked it first.

 

I like it... good work

 

Thanks.

 

I like it throw some paint on it and your set up

 

Very Nice! Looks better than my Radiator hose clamp/PVC coupler con-Craption!

 

nice

 

nice, i want to do something liek that now because my maglite is rattling in its current location

 

It definitely needs paint. I don't really like the way the foam is in there, it looks kinda sloppy, but it isn't really that visible. Over all, good job.

 

you could always drill two small holes at the ends of the pipe for the zipties to go through so u can cut the foam flush.

i like it though!

 

i stuck mine in the passenger door pocket.