is there any way to re glue the insulation back to the bottom of my truck above the transmission? It has come loose and is just hanging there or do I need it or can it just be taken out?

 

Just to let everyone know. Even though i got no responses i have figured it out, so no need to respond

 

Well how did you figure it out? It's always good to add more info to the forum!

 

There were a few places that there were screws sticking through the insulation, I got some of those push on bolts and some washers. I put the washer over the srew and then the push on nuts. This holds the insulation tight up against the body of the truck. I have put on over a 1000 kms and its still tight so I am satisficed with it. If for some reason it comes loose again I will squirt some silicne between the body of the truck and the insulation

 

Thanks!

 

You are welcome