i went out today and bought a fabtech spindle kit and 4" blocks for the rear, i'm installing them this weekend with my friend who really knows a lot about trucks, i just wanted to double check with you guys...am i gonna need anything else when i install the kit like new ball joints or anything like that? I also saw a thread where a guy was talkin' about needing a drive shaft after a lift...am i gonna need something like that. I'm really new at this and any info you guys can give me would be great.

 

not after a fabtech spindle lift, just make sure you don't beat on that spindle too much and you should be fine.

 

After 4" blocks in the rear, you may want to get some traction bars later on. becuase of axle wrap

 

you wont need a new driveshaft. that is for 4wds only.