are these hook ups for fog lights?





and if im not mistaken are these torsion barz?

 

Not torsion bars

 

yeah not t bars and the llights....hard to tell were the pic was taken

 

looking closer i say yes those are for the fogs

 

ok fogs good...i mean cause it seems like i can crank these bars just like torsion bars and it would lift it no?

 

i have the same lookin plugs at the front of my truck and those use to be my abs sensors for the front. are your sensors hooked up?

 

but my front abs is hooked up already....these are just sitting there

 

No, you don't have torsion bars, you have coil springs

 

yea then i guess they gotta be for the fogs

 

Those are the control arm bolts that hold them to the frame. Tightening them won't do anything except possibly ruin the bushings.

I'm leaning this way. Hard to tell really but they do look like the ABS sensor plugs to me.

 

but idk cause my front abs has alway been hooked up...i should have a light come on if they werent hooked up right?

 

Trace your lines. Its possible your truck only has RABS so in that case you wouldn't get a light.

 

ok well i have a few mins of light left hold on

 

ok those connectors go up beind my lamp and then my lamp connectors splice out of that...but the casing there in branches off tho the other side of the truck and then also go behind my fluid tanks

 

Your plugs look a lot like my fog light plugs, pretty much same location too...

 

but shouldnt the hookup for the fogs be an h10 style plug? thats completely different.

 

lol some one needs to make up their damn minds ...now im really confused

 

H10 would be for a 9145 bulb. 98-00's have 9006 bulbs for the fog lights but the plugs look similar. Now the one you posted Andrew, doesn't look like it would work for any bulb i've seen anyway. Im going to have to go with the ABS as well.

 

me too lol, the connections for the fog harness lead to an h10 style plug direct to the light, it doesnt have a split it it for that style of plug anywhere i can place in my mind. im still thinking your abs sensors were left in the old spindles or you never had them at all. did you reinstall front abs sensors in the new spindles? if so it doesnt look like you hooked them up?

 

.

 

Easy way to check, pull your radio bezel and see if there is a spot for a factory fog light switch, if so it's for fogs, if not then it's front ABS!

 

lol now that you mention it i do have rear abs lol....i never had a sensor on the front when i took out the old spindles

 

where am i checking again billy?...on the actual bezel it self or a harness

 

then you got er, but im surprised your truck dont have front abs,, and still has the plugs??!

 

ya idk...cause i took off the old spindles and never disconected any wire...