I have a 00 xlt 2wd thats been leveled i currently run 30x9.5x15 it has 7x15 wheels

Wanting to bump up to 10.5 or 11 ish i have a little lift and full offroad bumpers so clearance is there with exception of control arm rub if i go past 9.5.

Its getting a 6in lift and new wheels n rubber was thinking 33x12x15s and regear its a daily but mostly a prerunner build toy since most my roads to work are dirt.

Whats a good off set to clear lca and frame fenders are baja 6in and rears are cut with flares.

Thanks

 

Not quite following but............

If 9.5" width is OK and you want 12" then that's 2.5" wider over all. so 1.25" from center line, so that's the offset change you want, if you think you can get away with 1" then use 1" spacer

If you are getting new wheels then stock Ranger backspace is 4.5", you would want 3.25" or 3.50" backspace with 12" width

 

3.5 is probly what i will go with to allow a bit more room when airing down tires a bit for sand n such.

Thank you .