Hillbank Thunderbolt exhaust pictures
#1
#2
#3
Hey Bill and 4X2XLT, I picked up the same exhaust also, and would like to see how it looks exiting the rear without the rollpan cutouts? or im wondering if the tail sections could be bent to exit each side behind the wheel.
Going to wait till spring to install, by then my muffler should be rusted through completly
Going to wait till spring to install, by then my muffler should be rusted through completly
#4
Originally Posted by Rob99
or im wondering if the tail sections could be bent to exit each side behind the wheel.
Last edited by Cape Fear; 12-28-2005 at 11:47 AM.
#5
#6
Originally Posted by Rob99
Hey Bill and 4X2XLT, I picked up the same exhaust also, and would like to see how it looks exiting the rear without the rollpan cutouts? or im wondering if the tail sections could be bent to exit each side behind the wheel.
Going to wait till spring to install, by then my muffler should be rusted through completly
Going to wait till spring to install, by then my muffler should be rusted through completly
#9
Im going to have a shop install it, probably Mufflex in Trenton (NJ) I'll have them install it all step back and see if i like it, if not them have them bend the pipes, of course letting them know what my ideas are first and make sure they would do it (im sure they will, they do custom exhausts all the time)
And im not to sure how the drivers side exit would hang/mount have to look under there.
This type of exit would also eliminate the tightness fitting around the spare to.
And im not to sure how the drivers side exit would hang/mount have to look under there.
This type of exit would also eliminate the tightness fitting around the spare to.
Thread
Thread Starter
Forum
Replies
Last Post
zabeard
General Ford Ranger Discussion
10
03-28-2007 03:01 PM
jdpartsman99
4.0L OHV & SOHC V6 Tech
25
08-03-2006 07:13 PM
jtslmn720
General Ford Ranger Discussion
14
04-22-2006 10:44 AM