[Turn Signal Mirros] Which wires to splice into?
#1
[Turn Signal Mirrors] Which wires to splice into?
I'm in the process of installing turn signal mirrors, and can't figure out which wires to splice into. For the drivers side I spliced into a green/orange wire under the dash, when I grounded it the turn signal mirror doesn't flash with the turn signal, it just stays lit all the time.
Does anyone have pics of the wires that you need to splice?
Thanks
Does anyone have pics of the wires that you need to splice?
Thanks
#5
Here's what I did...
The ground, I put a ring terminal and utilized one of the mirror mounting studs.
For the power, I previously performed the "turn signal mod" that makes the corner lamp alternate with the turnsignal.....I simply routed the power wires for the mirror signals through the firewall, and connected them to the "jumper" wire on the "turn signal mod". Left to the left, and right to the right.
Hope i helped.
The ground, I put a ring terminal and utilized one of the mirror mounting studs.
For the power, I previously performed the "turn signal mod" that makes the corner lamp alternate with the turnsignal.....I simply routed the power wires for the mirror signals through the firewall, and connected them to the "jumper" wire on the "turn signal mod". Left to the left, and right to the right.
Hope i helped.
#6
#10
Thread
Thread Starter
Forum
Replies
Last Post
crucialcolin
General Technical & Electrical
0
07-26-2009 04:14 AM