SuperLift Front Driveshaft U-Joints
#2
#5
Mine was making a bad rattling noise so I called superlift and they dont sell a rebuild kit. They gave me the manufacture called Neatco that sells it but you have to be a dealer to buy from them. I went to my local auto parts house and they matched them up and I rebuilt it myself. No more noise.
#6
#10
1-0154.........2 Times
1-0153.........1 Time
The brand I got was Percision u joints and for all it was about 40 bucks for the parts. Hope this helps
#11
These are the same u-joints as as what are in the XJ shaft I made for my Superlift. The ONLY difference between a 1-0153 and 1-0154 joint is the grease fitting....and the price! Just get three 1-0153s. They're 1/2 the price of the 1-0154. 1-0153 has a regular grease fitting and the 1-0154 has a button type fitting for clearance reasons.
From the looks of mine the regular fitting will clear... or you can try to reuse your old fittings. Or just grab two new ones... it will still be cheaper than buying the 1-0154s.
From the looks of mine the regular fitting will clear... or you can try to reuse your old fittings. Or just grab two new ones... it will still be cheaper than buying the 1-0154s.
#12
And if you need any other parts... just get your parts guys to look up the front shaft of an early 90's XJ or an older Ranger/Explorer. They all seem to use the same parts from the measurements I've received and the research I did while building mine.
They all use a 7-0082NG centering yoke and a N2-26-367 H-yoke.
They all use a 7-0082NG centering yoke and a N2-26-367 H-yoke.
#14
Thread
Thread Starter
Forum
Replies
Last Post
lifted97ranger
General Ford Ranger Discussion
2
10-06-2006 02:28 PM