Yeah man ive honestly been a member on here for a long time just never have put up pics or signature. I actually normally spend most of my time on FRF but I like it over here to just was waiting for my new rims n 33's to put on to post abunch of pics n everything.

N shelton I have 06+ mirrors so I dont think your glass will work unless you have the same style but I appreciate the help.

 

honestly i would just take it to a local glass shop..you might be surprised at how cheap it would be to let a pro do it for you!! yeah i had a 3"BL and cranked front bars (#1's) i had to trim the lower valance in the lil corner there by tire....not much but just a hair..it grabbed at full lock in reverse was the only prob i had!

 

Hah gosh man, Ive had that happen - sliding sideways into someones yard.. but for me it was because of an oil slick, a extra low geared bronco with a locked rear end, and a sharp corner - going about 20 mphn around the corner, both tires spun out with no traction and it shot me sideways into a guys yard.. I hopped out because I noticed he was out there and let him know what I did.. he took a look and said it wasnt a biggy at all - so i slowly crawled out of his yard and kept on my way!

 

just order the one off ebay. it was like $21 shipped. it has instruction with it and everything. took 20 minutes to do. i used a screw driver to get the old glass out and put the new glass in with the sticky pads it came with. looks factory. no problems what so ever.

 

so what do you think I should do when I get mine mounted at sears, liek to prevent them from rubbing when they test drive?

 

then i would go ahead a trim about a 1/4" off that lower corner of lower plastic valance.... you can do it in such a way that its not notceable to even you after awhile..lol i used a dremel to do mine worked great and fast!!

 

did you trim only the black lower part or the black n grey part that you have shown?

 

yeah i just trimmed the lower black plastic piece

 

how much?

 

1/4"...............a quarter of an inch...............lol

 

you didnt have to trim the inside liner any or nothing? and is your front perfectly level with your rear or is your nose down alil?

 

That sucks, man. Seriously. Glad it wasn't too bad.

By the way, you know what else sucks? typing "n" instead of "and". It's annoying as **** to read, LOL.

 

haha when your at work and typing on the forum from your cell phone, you tend to do things like that to make your life easier lol.

 

no you dont have to do anything to the plastic inner fender (spash shield) and my front end was a lil higher than my rear until it sagged a lil bit...but you just trim that lower valance and your all good!!

 

The nerve of some people.