ok, so i picked up this tinted rear slider out of a 99 ranger that was turned in for the C4C program, and so i put it in my 2006, and i noticed my 06 rear window had a couple of extra studs on the window(no problem) but what i noticed is i have about a 1/16 of an inch gap between the cab,a dn the rubber trim on the window... now did ford change the rear window sill, or what?

 

Oh **** that sucks huge monkey nuts leave it to them to change the one thing on the cab that doesent need to be redesigned

 

i also found out that i can't run 98-older tail lights, they put a nice lip behind where the reflector is on the 06 tails... F'n ford

 

Why would you want to run 98 and older taillights?

 

i have a pair of rare red/clear/red TYC tails, and i tought they would look nice on it

 

If you want to run them get a dremel and do some trimming then prime the bare metal.

 

hey svt where did you get those tails?

 

Those tails are ugly as he'll. Leave the stockers

 

ya, leave the stockers. as for the window....is there a seal issue also?

 

i cleaned the old seal out, and cleaned off the surface it mounts to on the cab, and installed a new seal that was thinner then what i used last time thinking that was the problem there, but still doing the same thing