stock upper camber brackets
#1
#4
#5
#6
I just changed my upper control arms on my 03 2wd (coil springs).
2 things....You can probably see some sort of a rust outline where they sat for the last xxxxxxx miles. On mine you can see an outline clearly, and I put it back in the same spot.
Also, for some reason, for coil spring trucks, MOOG arms are not greasable, no nipples, and do not seem to be pressfit! I do not know why, but I seem to be a bit dissappointed.
Any the stock alignment cams that I have seen in every picture (the oval ones) are not present on my truck. A flag bolt on one side, and a square washer on the other side.
Can anyone comment on this?
2 things....You can probably see some sort of a rust outline where they sat for the last xxxxxxx miles. On mine you can see an outline clearly, and I put it back in the same spot.
Also, for some reason, for coil spring trucks, MOOG arms are not greasable, no nipples, and do not seem to be pressfit! I do not know why, but I seem to be a bit dissappointed.
Any the stock alignment cams that I have seen in every picture (the oval ones) are not present on my truck. A flag bolt on one side, and a square washer on the other side.
Can anyone comment on this?
Thread
Thread Starter
Forum
Replies
Last Post
dogfish246
General Ford Ranger Discussion
0
06-10-2014 01:57 PM
Want to Buy: stock i beam mount brackets - TX
the downlow
OLD - Suspension, Tires, & Wheels
1
04-13-2011 01:41 PM
Tys 4x4 FTW
OLD - Interior, Exterior, Electrical, & Misc.
9
10-02-2010 09:39 PM
08rangerxl
OLD - Interior, Exterior, Electrical, & Misc.
2
07-19-2009 11:47 PM