00’ 3.0L flex- starter won’t disengage
#1
00’ 3.0L flex- starter won’t disengage
Hi there, on my third starter. 🤦-♂️
tested the solenoid on the current one, no juice when key in in the on position, crank it over engine starts but terrible grinding at the bell housing/starter connection
bolts are tight, no shorts in the cables. Issue arose after hitting original starter with a hammer to start it for 2 weeks... I’m not a car guy but out of necessity I can do most part replacement that’s not internal.
Ignition? Thanks fellas
I do appreciate the community help
tested the solenoid on the current one, no juice when key in in the on position, crank it over engine starts but terrible grinding at the bell housing/starter connection
bolts are tight, no shorts in the cables. Issue arose after hitting original starter with a hammer to start it for 2 weeks... I’m not a car guy but out of necessity I can do most part replacement that’s not internal.
Ignition? Thanks fellas
I do appreciate the community help
#2
Thread
Thread Starter
Forum
Replies
Last Post
mtman1983
General Ford Ranger Discussion
3
02-15-2012 06:41 PM