05 Dome Light Standard Op
 

How does this dome light work ? I know if you leave the door open or the manual roll switch ON, it times out in 5 minutes. But sometimes i open the door and it does not come on. What is sop with this light ? Can you defeat the time out ?

There is a Door switch in each door, if this switch is grounded then the SJB(body computer) will activate the Dome light relay turning dome light on, Door Ajar light should also come on

The dimmer wheel can power the dome light directly without SJB

But the dome lights 12volts comes from the Battery Saver Relay either way
And SJB will turn off Battery Saver relay usually after 20min, not 5 min, if key is off, if you leave the key on then dome light should stay on until Battery is dead

These relays are inside SJB and not easily accessible, seen here: https://www.therangerstation.com/tec..._project-9.jpg

Mine turns off in 5. What is wrong ? Sometimes it won’t come back on after closing all doors and rolling the dimmer off. It seems to do what it wants when it wants.

Does dome light come back on again with key On and then key off, for another 5min?

Also does the Door Ajar Light come on when you open the driver's door, if not then SJB is not getting the grounding signal from that door switch
Try opening passenger door
Unless the SJB gets that ground signal the battery saver relay will stay off so no power for dome light

I have only seen 20-40min time delay for battery saver relay myself

Ok. I found that it had a 922 bulb. No good. Should be 912. Too many amps . So i picked up the Sylvania 912 st silverstar.

It wouldn’t come on at first. I tapped and rocked on the relays. It came on. Now so far it is working. I timed it with my iphone stop watch. It stayed on past 10 minutes and i just cancelled the test. Probably would have gone another 10.

What is this connection ? IS THERE MORE TO THE WIRE DIAGRAM LIKE A CHART SAYING WHAT 14 IS, WHAT C2280B IS ?
https://cimg4.ibsrv.net/gimg/www.ran...656761ae4.jpeg

C2280's are the 4 Larger connectors on the SJB, they are C2280 A, B, C and D
14 is the pin number on connector C2280B

C2280 designations seen here: https://www.justanswer.com/uploads/A...mart_panel.png

This article has pictures of the SJB: https://www.therangerstation.com/tec...horn_mod.shtml

The Interior Lamp relay is a 5 pin relay, when it's activated the arrow will point to the right and 12v will flow to dome light, pin 14, if Battery Saver relay is ON
When Interior Light relay is OFF then the arrow points to the left, which is the connection to Dimmer Wheel switch, pin 10
So if you turn dimmer up all the way it will send 12v to pin 10 and power up the dome light(pin 14), but only if Battery Saver Relay is still ON

I suspect an intermittent battery saver relay.

Wish i could jump it.

About Fed Up
 

My dome light quits working intermittently. To get it back on, i tap on the group of blade fuses with the butt of my pocket knife. It comes back on.

WTH is wrong with this ?

https://cimg4.ibsrv.net/gimg/www.ran...950b91fb6.jpeg

I would pull off the kick panel

That's the SJB(smart Junction Box) behind it
It is the "Body Computer", runs all the cab electrics

Looks like this: https://www.therangerstation.com/tec..._project-5.jpg

There are 4 large wire connectors, each has a lever on it, you pull on the lever to push up the connector away from the SJB
Unhook Battery Negative cable first
Then unplug each connector
Look at each connector and its base/plug-in for corrosion, clean it if seen
Then plug it back in
Unplugging and plugging back in CLEANS each pin and slot if there was no obvious corrosion seen
Do each connector

Also unplug and look at the 2 relays, black boxes at bottom left

You can also unplug and plug back in each fuse if you want

If problem still happens then you will need to change the SJB, its an internal issue, inside this part of the SJB: https://www.therangerstation.com/tec..._project-9.jpg

No programming is needed, and there are just two models, with keyless entry(fobs), and without keyless entry(no fobs)
And no, you can't added keyless entry just by changing the SJB, lol