06 Ranger 4x4 - 4.0L driver side front wheel skids
06 Ranger 4x4 - 4.0L driver side front wheel skids
Greetings everyone a 'newbie here' I hope this is the right place to ask questions about brakes / ABS.
Symptom: When braking suddenly the driver side front wheel skids - no check engine or ABS lights are on.
So far I've replaced the following:
Both front calipers and pads, the brake line going to the caliper on the drivers side, and checked both front brake rotors. Also blead both front brake calipers.
A few years back the front wheel bearings were replaced so I don't suspect there is anything going on with the speed sensors.
My next steps were to remove / clean the front wheel speed sensors (for good measure), then clean and bleed the rear brakes (again for good measure)
So far from what I see elsewhere the issue may be with the ABS pump itself. Soooo - has anyone else seen this problem?
Does it make sense to remove the ABS pump, take it apart and clean it?
Worse case if I have to replace the ABS pump whom do ya all purchase those from? I've heard it mentioned that there are places that rebuild them - any recommendations on that?
Also if the ABS pump is replaced I've seen it mentioned that it needs to be re-programed for my particular truck- does that mean it's a trip to a Ford dealership - anyone know how much they charge to do that?
Thanks in Advance for any help or insight into this issue.
I'm guessing someone has seen this before.
Thanks again
Jan
Symptom: When braking suddenly the driver side front wheel skids - no check engine or ABS lights are on.
So far I've replaced the following:
Both front calipers and pads, the brake line going to the caliper on the drivers side, and checked both front brake rotors. Also blead both front brake calipers.
A few years back the front wheel bearings were replaced so I don't suspect there is anything going on with the speed sensors.
My next steps were to remove / clean the front wheel speed sensors (for good measure), then clean and bleed the rear brakes (again for good measure)
So far from what I see elsewhere the issue may be with the ABS pump itself. Soooo - has anyone else seen this problem?
Does it make sense to remove the ABS pump, take it apart and clean it?
Worse case if I have to replace the ABS pump whom do ya all purchase those from? I've heard it mentioned that there are places that rebuild them - any recommendations on that?
Also if the ABS pump is replaced I've seen it mentioned that it needs to be re-programed for my particular truck- does that mean it's a trip to a Ford dealership - anyone know how much they charge to do that?
Thanks in Advance for any help or insight into this issue.
I'm guessing someone has seen this before.
Thanks again
Jan
Thread
Thread Starter
Forum
Replies
Last Post
omgbossis21
General Technical & Electrical
20
Oct 7, 2015 12:56 AM



