2003 Edge 2WD wipers quit. Which wires do I jump to isolate if the switch is the prob
 

https://cimg2.ibsrv.net/gimg/www.ran...3526c03a01.jpg

https://cimg1.ibsrv.net/gimg/www.ran...8d1e063474.png
https://cimg2.ibsrv.net/gimg/www.ran...3ee0a18350.png

I don't see the 7 pin connector at wiper switch, thank you.

How are you going to do the test? You looking for resistance in the switch?

No, I know which wire is hot. Need to know if I can jump it to other prong to see if motor turns on. I know the motor works. Right now on relay 45B I have removed relay and jumed across it and motor runs.

Looks like 1 and 6 are ref voltage and 4 is ground as this is a ground switched device. so you should able to jump 4 to 6. This is going to the body mod so be sure the diagram is the correct one.

https://cimg6.ibsrv.net/gimg/www.ran...db8ae471fd.jpg
https://cimg7.ibsrv.net/gimg/www.ran...1b7887315e.jpg

Thank you for the schematic that's the one I need !

After trouble shooting isolated to GCM. I put in freezer for 24 hours and now wipers work ! Contact must have stuck. I'd used this before on CAN systems of railroad equipment.

GCM being the body module? I wasn't aware they contained mechanical relays. Wonder if if may have been a bad solder joint? At any rate good trick to know, thanks!