2003 Edge 2WD wipers quit. Which wires do I jump to isolate if the switch is the prob

Reply Subscribe

Thread Tools

Search this Thread

08-23-2018

Trkdog

Member

Thread Starter

Join Date: Jul 2018

Location: Louisville

Posts: 7

Likes: 0

Received 0 Likes on 0 Posts

2003 Edge 2WD wipers quit. Which wires do I jump to isolate if the switch is the prob

Reply Like

08-23-2018

kenhigg

Member

Join Date: Aug 2018

Location: Winston, Ga

Posts: 114

Likes: 0

Received 0 Likes on 0 Posts

Reply Like

08-23-2018

Trkdog

Member

Thread Starter

Join Date: Jul 2018

Location: Louisville

Posts: 7

Likes: 0

Received 0 Likes on 0 Posts

Quote:

Originally Posted by kenhigg

I don't see the 7 pin connector at wiper switch, thank you.

Reply Like

08-23-2018

kenhigg

Member

Join Date: Aug 2018

Location: Winston, Ga

Posts: 114

Likes: 0

Received 0 Likes on 0 Posts

How are you going to do the test? You looking for resistance in the switch?

Reply Like

08-23-2018

Trkdog

Member

Thread Starter

Join Date: Jul 2018

Location: Louisville

Posts: 7

Likes: 0

Received 0 Likes on 0 Posts

Quote:

Originally Posted by kenhigg

How are you going to do the test? You looking for resistance in the switch?

No, I know which wire is hot. Need to know if I can jump it to other prong to see if motor turns on. I know the motor works. Right now on relay 45B I have removed relay and jumed across it and motor runs.

Reply Like

08-23-2018

kenhigg

Member

Join Date: Aug 2018

Location: Winston, Ga

Posts: 114

Likes: 0

Received 0 Likes on 0 Posts

Looks like 1 and 6 are ref voltage and 4 is ground as this is a ground switched device. so you should able to jump 4 to 6. This is going to the body mod so be sure the diagram is the correct one.

Reply Like

08-23-2018

kenhigg

Member

Join Date: Aug 2018

Location: Winston, Ga

Posts: 114

Likes: 0

Received 0 Likes on 0 Posts

Reply Like

08-23-2018

Trkdog

Member

Thread Starter

Join Date: Jul 2018

Location: Louisville

Posts: 7

Likes: 0

Received 0 Likes on 0 Posts

Thank you for the schematic that's the one I need !

Reply Like

08-31-2018

Trkdog

Member

Thread Starter

Join Date: Jul 2018

Location: Louisville

Posts: 7

Likes: 0

Received 0 Likes on 0 Posts

After trouble shooting isolated to GCM. I put in freezer for 24 hours and now wipers work ! Contact must have stuck. I'd used this before on CAN systems of railroad equipment.

Reply Like

#10

08-31-2018

kenhigg

Member

Join Date: Aug 2018

Location: Winston, Ga

Posts: 114

Likes: 0

Received 0 Likes on 0 Posts

GCM being the body module? I wasn't aware they contained mechanical relays. Wonder if if may have been a bad solder joint? At any rate good trick to know, thanks!

Reply Like