Ranger-Forums - The Ultimate Ford Ranger Resource

Ranger-Forums - The Ultimate Ford Ranger Resource (https://www.ranger-forums.com/)
-   General Technical & Electrical (https://www.ranger-forums.com/general-technical-electrical-18/)
-   -   2008 Ford Ranger Squeaking (https://www.ranger-forums.com/general-technical-electrical-18/2008-ford-ranger-squeaking-160713/)

taylortl 02-27-2020 01:13 PM

2008 Ford Ranger Squeaking
 
Hello,
I have a 2008 Ford Ranger.
There is a loud squeaking noise when I turn the steering wheel and when i push down on the front of the truck.

What causes this?

Scrambler82 02-27-2020 01:36 PM

My first thought is GREASE, how long since you, yourself, checked the grease fittings, make sure that grease has come out of the joint. ?
Even if you take your truck to a shop for grease, SOMETIMES they don't do it or just don't do a good job !


Next might be the Shocks, then you can get in to U-Joints on a 4x, Coil Spring, if you have them, can squeak in their seats, body bushings, and even wheel bearings... !

Tell us about your truck, that might help too !

taylortl 02-27-2020 01:39 PM

It is a 2008 Ford Ranger XLT 2WD with 108000 miles

Scrambler82 02-28-2020 10:53 AM

I used to use a product called "Rubber Lube", not sure if it is even available any more BUT get something to lube up all your bushings and see if the squeak goes away.

Check if all of your joint have grease. good places to start.


Ltr

Jason Bro 03-02-2020 11:27 AM

I had the same problem on my '99 4x4. Turned out to be a bad ball joint. Upper were greaseable, which I did,
lowers were not. So I just replaced complete upper and lower control arms, which after 220,000 miles needed to be done.
Oddly, the new set has greaseable lowers, but not the uppers.


All times are GMT -6. The time now is 11:18 PM.


© 2024 MH Sub I, LLC dba Internet Brands