hey, I have a 98 ranger xlt with 4.0, my abs light comes on when i get to about 10 mph then stays on until i shut off the engine. It doesnt come back on until i drive it again. Also my cruise control doesnt work and it did before abs light came on. I have replaced the sensor in the differential. Is it possible to test sensors in hubs or do i need to look elsewhere?

 

I would have any codes read too. See if it is throwing any.

 

i will try that, thanks

 

ob11 reader wont read codes, doesnt have sensors in hubs

 

you can always jack up your truck and grab the top and bottom of your tire and make sure your hub isn't out. thats what was wrong when my abs light came on

 

i concur, check the hub.

 

it is rear abs only,wanted to troubleshoot but couldnt find abs control module, any suggestions

 

See if this link helps Click Link

 

check the ABS Wheel Speed Sensors all of them

 

thanks rev if my 98 is the same as 91-96 it will help a lot, i didnt know autozone had that available on their website,