Im adding a new alarm system to protect my investment...

My truck came with the keyless entry, but how do you disconnect it?

 

you dont need to disconnect it you just tap into it for the new alarm if it has keyless.....also the ranger is a pretty tricky car to do if this is your first alarm install. We have sleeping door locks which "wake up" and send a pulse through the system which sets off aftermarket alarms every 10min if not done right

 

what!!! lol

Right now i just hooked up the sensors and the locks... tomarrow im doing the door/hood triggers and tappin into the ignition wires...


I actually am useing it right now and no alarms... i guess im doing ok then?

 

yeah chris you should do fine man just take your time... if you have trouble with the door sensors let me know. i had to work around the sleeping door locks by wiring my alarm to send an isolated pulse to the driver-side door open sensor wire to trick it into 'waking up' the system, and then sending a second pulse to unlock the doors.

 

or use the dome light for the door triggers thats what i did

 

how would i do that....


also, would i need to use diodes? I bought a few yesterday

 

def. get an alarm...

i found out that it's easy as hell to break into a Ford in less than 1 minute with the right tools.....

its scary...

 

i know...lol.. i already bought one and its installed!!!


all i need to do is the door triggers which im too lazy to do now

 

damn mazda owners...

 

^ ????

 

bump....

its all working BUT i didnt hook up the door sensors... also, somtimes it wont unlock cuz of the stupid stock alarm