halo fog lights
Thread Starter
|
Member
Joined: Dec 2009
Posts: 218
Likes: 0
From: port crane, new york
halo fog lights
hey im new to this forum, finally found people that are as crazy about their ranger as me. i got a 01 ranger xlt stepside 4.0 well i just bought some halo projector fog lights from ebay with no instructions and i dont have a clue on how to wire them any help would be appricated.
Thread Starter
|
Member
Joined: Dec 2009
Posts: 218
Likes: 0
From: port crane, new york
make a Image hosting, free photo sharing & video sharing at Photobucket account its really easy
Thread Starter
|
Member
Joined: Dec 2009
Posts: 218
Likes: 0
From: port crane, new york
Thread Starter
|
Member
Joined: Dec 2009
Posts: 218
Likes: 0
From: port crane, new york
I have the same ones. I tapped into the sidemarker wires for the halos(the red/black wires), and then just plugged the harness into the factory spot. When you take them apart because they leak, don't break them when you put them back together, you will be pissed because they don't sell the housings alone. Also, the bulbs that come with them aren't very bright, swap them with some silverstars and you are good to go.
I just pulled the sidemarkers out, then spliced in a positive and a negative wire off of each side and ran them down to the lights. I will try to take pics tomorrow, we are getting a blizzard right now, so I can't go out and take them now.
