General Technical & Electrical General technical and electrical discussion for the Ford Ranger that does not fit in any other sub-forum.

<<HELP.. Truck Wont Turn Over ..HELP>>

Thread Tools
 
Search this Thread
 
Old Jun 12, 2009
  #1  
johnson's Avatar
Thread Starter
|
Member
iTrader: (-1)
Joined: Nov 2005
Posts: 281
Likes: 0
From: Las Vegas, NEVADA
<<HELP.. Truck Wont Turn Over ..HELP>>

the truck is a 2003 4 bangwer 5 speed.....


i just bought the ranger up in tahoe from the guy that rolled it and did the cab swap..... it wont turnover from the key.... it has power to the guages and blinkers and all but wont turn over from the key.... i can jump it off the starter and it will turn over.... the neutral saftey switch is not under the dash, its in reach so i push that in so the ecu thinks the clutch is depressed, and still nothning...

any ideas.... im about to put a push button start in it if i cannot figure it out... but i know it is something simple....

help guys....

thanks
 
Reply
Old Jun 12, 2009
  #2  
DaisyDuke's Avatar
Member
Joined: May 2009
Posts: 128
Likes: 0
From: greenville sc
if you need it to run right this second pushed it to roll it to a start then pop it into first gear its a ford they have plenty of electical problems but id have to be there to tell you whats wrong good luck!
 
Reply
Old Jun 12, 2009
  #3  
johnson's Avatar
Thread Starter
|
Member
iTrader: (-1)
Joined: Nov 2005
Posts: 281
Likes: 0
From: Las Vegas, NEVADA
damn.... well i want to fix it not just push start.. haha well thanks...
 
Reply
Old Jun 12, 2009
  #4  
cchsbuzz19's Avatar
Member
iTrader: (5)
Joined: Jul 2007
Posts: 2,417
Likes: 2
From: North Canton, Ohio
If your not getting anything from the key, Your starter could have went bad.
 
Reply
Old Jun 12, 2009
  #5  
johnson's Avatar
Thread Starter
|
Member
iTrader: (-1)
Joined: Nov 2005
Posts: 281
Likes: 0
From: Las Vegas, NEVADA
ok... im gunna pull the starter and bunch test it and have checker test it,....
 
Reply
Old Jun 12, 2009
  #6  
FullThrottle02's Avatar
Member
iTrader: (3)
Joined: Apr 2008
Posts: 586
Likes: 0
From: McHenry,IL
Does that have PATS? It may be preventing it from starting IDK. Could be ignition switch related.
 
Reply
Old Jun 12, 2009
  #7  
Rev's Avatar
Rev
Member
Joined: May 2005
Posts: 1,179
Likes: 8
From: San Diego, CA
I believe there is a starter relay located in the BJB. The power flows from the clutch switch to the relay's coil. The coils ground is controlled by the PCM. If this relay is not functioning properly the starter will not work.
 
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
chop1381
Drivetrain Tech
4
Jun 17, 2019 09:31 PM
PDXracer
SOHC - 2.3L & 2.5L Lima Engines
3
Oct 6, 2014 07:41 PM
97RANGE23
SOHC - 2.3L & 2.5L Lima Engines
21
May 7, 2012 05:24 PM
ghostindadark
2.9L & 3.0L V6 Tech
0
Jun 28, 2009 01:31 PM
Off-roadranger04
4.0L OHV & SOHC V6 Tech
5
May 31, 2009 08:15 PM




All times are GMT -6. The time now is 05:31 AM.