General Technical & Electrical General technical and electrical discussion for the Ford Ranger that does not fit in any other sub-forum.

Problem!!!!!

Thread Tools
 
Search this Thread
 
Old Mar 4, 2008
  #1  
JakeH05's Avatar
Thread Starter
|
Member
iTrader: (1)
Joined: Jan 2008
Posts: 695
Likes: 0
From: Elberton, GA
Icon5 Problem!!!!!

Today, I got in the ranger after school and it wouldnt crank. Turns out it was a bad battery.So, we jumped it off and I went to drive it home and it wouldnt shift into 2nd or 3rd.It will shift into them after u rev it to the moon but it only does that every once and a while.Auto Trans. Dunno what the problem is? Maybe computer/sensor trouble? Any suggestions
 
Reply
Old Mar 4, 2008
  #2  
tluafeD's Avatar
Member
Joined: Mar 2008
Posts: 137
Likes: 1
From: Indianapolis, Indiana
not a clue, i drive a manual so... if your check engine light is on, go to autozone and have them run a diagnostic. thats all i can help you with. good luck
 
Reply
Old Mar 4, 2008
  #3  
meemooer's Avatar
Member
Joined: Mar 2005
Posts: 336
Likes: 0
From: Brunswick, Ohio
maybe the battery caused it to go into "Limp Home" mode. I didn't think fords have that, i know chevy's do as i've towed a few home because of that
 
Reply
Old Mar 4, 2008
  #4  
04blackedge's Avatar
RF Veteran
iTrader: (13)
Joined: Jan 2007
Posts: 23,426
Likes: 8
From: Durham, NC
Take it to autozone and see if its throwing any codes or anything.
 
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
ChargerOnDavins
General Technical & Electrical
4
Oct 3, 2010 05:58 AM




All times are GMT -6. The time now is 09:31 AM.