Troubleshooting Engine stall
#1
Troubleshooting Engine stall
Hi guys, was looking for help on getting rid of my engine stall as im not having much luck on it.
Truck: 2004 Ford Ranger , 4.0, 5 speed.
Problem: Truck will stall randomly while driving. Only happens to stall when slowing down to a stop ( when Rpm's go from engine strain to virtually low rpms ). I can watch the RPM's drop below 500 then it stalls. Sometimes it happens, sometimes it holds the Idle RPM fine. Other then engine stalling,truck runs good and drives good. I turn the key and continue on. Additionally, the truck will stall when going downhill if the rpm's go a bit low towards idle (1000 rpm ).
Troubleshooting Approach so far:
Clean IAC ( X )
New fuel with fuel injector cleaner ( X )
Cleaned MAF Sensor ( X )
Going to test Fuel Pressure next
Any additional input or ideas to troubleshoot would be great. I also checked for vacum leaks, i have not noticed any hissing, I also checked the PCV hose locations, however the lines are in good shape and look new.
Thanks
Truck: 2004 Ford Ranger , 4.0, 5 speed.
Problem: Truck will stall randomly while driving. Only happens to stall when slowing down to a stop ( when Rpm's go from engine strain to virtually low rpms ). I can watch the RPM's drop below 500 then it stalls. Sometimes it happens, sometimes it holds the Idle RPM fine. Other then engine stalling,truck runs good and drives good. I turn the key and continue on. Additionally, the truck will stall when going downhill if the rpm's go a bit low towards idle (1000 rpm ).
Troubleshooting Approach so far:
Clean IAC ( X )
New fuel with fuel injector cleaner ( X )
Cleaned MAF Sensor ( X )
Going to test Fuel Pressure next
Any additional input or ideas to troubleshoot would be great. I also checked for vacum leaks, i have not noticed any hissing, I also checked the PCV hose locations, however the lines are in good shape and look new.
Thanks
Thread
Thread Starter
Forum
Replies
Last Post
Crunchy
General Ford Ranger Discussion
7
10-07-2013 09:00 AM
pdigiacinto
2.9L & 3.0L V6 Tech
16
03-03-2009 02:32 PM
Vulcancruiser
General Technical & Electrical
8
04-30-2006 07:20 PM