Any easy way to thread wire of the OHC...
#1
#2
I used the rubber grommet that the parking brake cable goes out through. Or is it for something else? Anyway, there is a large rubber grommet under the dash on the drivers side, below the master cylinder level. I made a small slit in the periphery of it and I have bunches of wires threaded through there.
The only wire you need to pass through there is one pair for the sensor. If you use a twisted pair in a "sheath", that's only one cable to pass through and it's very easy. I do hope you're not using the original harness that far down.
The only wire you need to pass through there is one pair for the sensor. If you use a twisted pair in a "sheath", that's only one cable to pass through and it's very easy. I do hope you're not using the original harness that far down.
#3
Originally Posted by n3elz
I used the rubber grommet that the parking brake cable goes out through. Or is it for something else? Anyway, there is a large rubber grommet under the dash on the drivers side, below the master cylinder level. I made a small slit in the periphery of it and I have bunches of wires threaded through there.
The only wire you need to pass through there is one pair for the sensor. If you use a twisted pair in a "sheath", that's only one cable to pass through and it's very easy. I do hope you're not using the original harness that far down.
The only wire you need to pass through there is one pair for the sensor. If you use a twisted pair in a "sheath", that's only one cable to pass through and it's very easy. I do hope you're not using the original harness that far down.
Nope, the original wiring ends at the begging of the a pillar. I'll take a gander at it tommorow.
#5
Thread
Thread Starter
Forum
Replies
Last Post
fordredneck
4.0L OHV & SOHC V6 Tech
10
09-29-2010 04:51 PM
WowMike2001
General Technical & Electrical
6
08-30-2009 08:05 PM