I tried the search on this, but couldn't find the answer I am looking for. Like most everyone on this site, I have the 60/40. The drivers side is developing a low spot in it. So rather than hack the existing seat and do the 40/40 mod, I figured I would just replace both seats w/new buckets. I am wanting something w/a little more bolstering in them. I am think of perhaps putting in seats out of a ZX3 or newer focus. Has anyone done this? Will they bolt onto the ranger brackets/sliders? I appreciate any input you guys might have.

 

i highly doubt they would just bolt up.. they are pretty nice seats though, my friend has a 2007 ZX3..

 

Thanks. I haven't seen anywhere on here where anyone has done this. I guess it is the same as any other seat swap, fab up some mounts. Well, I guess the saying is true, "You can't have your cake and eat it too".