So I know what I want and can picture it.
I hope it comes out as planned.

Here are some pics as of now.
It's going real slow.

As of Friday 2/29




Ya... The mold is still drying. Had to move it out of the house (stunk it up pretty good) and into 20ish degree garage. Might also be wrong hardener I used.

 

Whats this for?

 

looks like he just made the cup holder reach out alittle farther..idk i could be wrong

 

Yep pretty much. But there is no cup holder there.

I just made a mold of my lower(front) center console(sits where the 5speed should be). I will be extending it a few inches and also making provisions for at least one more power point, my cell phone, iPod, and GPS.

After the mold finaly dries I will cut and extend it and than make the final piece and add all the goodies onto it.

 

Cool sounds good, make sure to keep us updated

 

Update:

I got the fiberglass mold and original piece seperated.

I definatly did somthing wrong.
I finished the fiberglass mold abour 10pm last friday.
Its still sticky in flaces and almost the entire underside that was touching the wax paper is still wet and sticky.

Hopefully it will fully dry soon, now that air can get at both sides.