Explorer seat question
#1
Explorer seat question
I'm using the seats from the explorer I'm using for my v8 swap. I just have a question about the wiring. I know that the all black is ground and the black/white is power. The harness that plugs into the seats have a yellow/gray and a light blue/white. Do I need to use those wires at all? On the seats theres only the black wires that go into the harness. Hope that makes sense.
#5
Here's how Ford wired the Ex seats in 2000
Seat motors:
BK/WH - 25A fused circuit, always hot
Heaters:
LB/WH - 30A fused circuit, always hot
GY/YE - 7.5A fused circuit, hot in run
Ground:
BK
Each of the 3 power circuits is from a single fuse, then split to the two seats. Be sure to use adequate wire gauge for the nominal current in each circuit.
The heater switch is usually on the outboard side of each seat, near the motor controls.
Seat motors:
BK/WH - 25A fused circuit, always hot
Heaters:
LB/WH - 30A fused circuit, always hot
GY/YE - 7.5A fused circuit, hot in run
Ground:
BK
Each of the 3 power circuits is from a single fuse, then split to the two seats. Be sure to use adequate wire gauge for the nominal current in each circuit.
The heater switch is usually on the outboard side of each seat, near the motor controls.
Thread
Thread Starter
Forum
Replies
Last Post