New Member
Thread Starter
|
Member
Joined: Oct 2017
Posts: 5
Likes: 0
From: Canton, Michigan
New Member
Hello Everyone! My name is Garrett and I'm a new member, however I've browsed the site and similar Ranger sites ever since I got My Ranger back in 2010. I am also a member of the Blue Oval Militia site (Previously the Ranger Militia). Im 24 and a Michigander in the Plymouth-canton area.
The current specs of my Ranger are as follows:
2004 Ford Ranger XLT FX4 OffRoad
Extended Cab Sonic Blue
4.0L V6 "Cologne" 166k miles
5R55E Automatic w/ OverDrive 71k miles (rebuild at 95k due to overdrive band snapping and digging into the case)
Borg-warner 1354e t/c
Stock Suspension
DANA 35 front and Ford 8.8 rear with 4.10 gears in both.
MODS:
Alpine radio
SPYDER HID Projector head lights with HALOs, Black edition
Black Pro Comp Alloy Series 32 rims with stock 245/75/R16 Goodyear Wrangler Armortrac tires.
RIGID LED Fog lights and 12 light bar in front bumper valance
Interior has been mostly gutted. Replaced carpet with Rhino liner. removed rear dropseats as well as front 60/40 and replaced fronts with Cipher racing seats (CPA1017FBKBU) and 4-point Harness (CPA4002BL)
Harness is bolted to the bottom of the seat frame and to a custom partial rollcage i had made at my local Fabricators, since they make race car cages.
Between the front seats is a FAT 50 cal can for storage
1/0 gauge wire ran into the cab for amp and OBA
150 psi Air Horn
Red LED lights in interior and grill, and Front view camera in grill
IN-PROGRESS/FUTURE:
SCT Livewire TS programmer
floor console with switch panel, digital pressure gauge, CB radio and display for front and rear cameras
Full roll cage
On Board Air system (VIAIR 200psi system)
Subs in the clam doors (AKA Suicide Doors) and Amp
Rock lights
Chase rack with room for 2 spares and fuel and roof rack with lights (360 coverage)
PAINLESS TrailRocker 8 relay kit for lights
4" Superlift kit with add-a-leaf and 2" shackle in the rear
SSBC rear disk brake conversion
ME00StepSide Front coil-over conversion
Front winch bumper with stinger bar
MAYBE a MODDBOX supercharger kit.
Exhaust work.
Sorry this has gotten rather lengthy. Ill post a Built Blog/thread as i go/remember to. Once again, Hello everyone and thank you for your time, patience, ideas and support! I look forward to getting to learn from and chat with all of you!
The current specs of my Ranger are as follows:
2004 Ford Ranger XLT FX4 OffRoad
Extended Cab Sonic Blue
4.0L V6 "Cologne" 166k miles
5R55E Automatic w/ OverDrive 71k miles (rebuild at 95k due to overdrive band snapping and digging into the case)
Borg-warner 1354e t/c
Stock Suspension
DANA 35 front and Ford 8.8 rear with 4.10 gears in both.
MODS:
Alpine radio
SPYDER HID Projector head lights with HALOs, Black edition
Black Pro Comp Alloy Series 32 rims with stock 245/75/R16 Goodyear Wrangler Armortrac tires.
RIGID LED Fog lights and 12 light bar in front bumper valance
Interior has been mostly gutted. Replaced carpet with Rhino liner. removed rear dropseats as well as front 60/40 and replaced fronts with Cipher racing seats (CPA1017FBKBU) and 4-point Harness (CPA4002BL)
Harness is bolted to the bottom of the seat frame and to a custom partial rollcage i had made at my local Fabricators, since they make race car cages.
Between the front seats is a FAT 50 cal can for storage
1/0 gauge wire ran into the cab for amp and OBA
150 psi Air Horn
Red LED lights in interior and grill, and Front view camera in grill
IN-PROGRESS/FUTURE:
SCT Livewire TS programmer
floor console with switch panel, digital pressure gauge, CB radio and display for front and rear cameras
Full roll cage
On Board Air system (VIAIR 200psi system)
Subs in the clam doors (AKA Suicide Doors) and Amp
Rock lights
Chase rack with room for 2 spares and fuel and roof rack with lights (360 coverage)
PAINLESS TrailRocker 8 relay kit for lights
4" Superlift kit with add-a-leaf and 2" shackle in the rear
SSBC rear disk brake conversion
ME00StepSide Front coil-over conversion
Front winch bumper with stinger bar
MAYBE a MODDBOX supercharger kit.
Exhaust work.
Sorry this has gotten rather lengthy. Ill post a Built Blog/thread as i go/remember to. Once again, Hello everyone and thank you for your time, patience, ideas and support! I look forward to getting to learn from and chat with all of you!
Thread
Thread Starter
Forum
Replies
Last Post
waterboy
2.9L & 3.0L V6 Tech
10
Jul 21, 2007 05:19 PM
