New From VA
#1
New From VA
Hello All,
I drive a 99 Ranger XLT with 7 inches of total lift and 33's, a friend told me about this site so I hope you all can enlighten me on a few problems I have. This probably isn't the place to ask but I'm about to replace the front OEM drive shaft for a second time (it is wearing and rattling at the joint that goes into the transfer case) and was wondering if anyone knew whether the aftermarket Superlift drive shaft made specifically for our lifted rangers would fix my problem? The other problem I have is with my front tires wearing in the inside only, I have taken it to the alignment shop and they have tighten the camber as far as it can go; any ideas what I should do? Would adjusting the torsion bars do anything? Thank You All for Your Help!
SORRY for posting these questions here!
I drive a 99 Ranger XLT with 7 inches of total lift and 33's, a friend told me about this site so I hope you all can enlighten me on a few problems I have. This probably isn't the place to ask but I'm about to replace the front OEM drive shaft for a second time (it is wearing and rattling at the joint that goes into the transfer case) and was wondering if anyone knew whether the aftermarket Superlift drive shaft made specifically for our lifted rangers would fix my problem? The other problem I have is with my front tires wearing in the inside only, I have taken it to the alignment shop and they have tighten the camber as far as it can go; any ideas what I should do? Would adjusting the torsion bars do anything? Thank You All for Your Help!
SORRY for posting these questions here!
#6
that site I was tellin you about is here: www.stuffforyourranger.com and the exact link for the driveshaft is here:
http://www.stuffforyourranger.com/st...roducts_id=100
http://www.stuffforyourranger.com/st...roducts_id=100
#10
Thread
Thread Starter
Forum
Replies
Last Post