Spraying Rocker Panels?
#32
#33
#34
I took a sanding sponge and roughed up the panels
Then wiped it down real good and masked it off
Then took the rust oleum bed liner and sprayed 3 coats of it on
Also sprayed on the inside of the door
And let sit for about 2 hours till i pulled the masking tape and paper off and now letting dry
It took a little over 1 can with doing the tail gate
Then wiped it down real good and masked it off
Then took the rust oleum bed liner and sprayed 3 coats of it on
Also sprayed on the inside of the door
And let sit for about 2 hours till i pulled the masking tape and paper off and now letting dry
It took a little over 1 can with doing the tail gate
#41
#43
#44
I really like the look of doing this and I have some rust/dings on my rocks and bottoms of my doors but I really want to know how the spray on holds up where the coating meets the paint? If preped properly how long can I expect it to last? and would you recomend a roll-on instead of sprayon?
#45
Thread
Thread Starter
Forum
Replies
Last Post
tycksena
General Technical & Electrical
10
02-13-2014 06:51 PM
yellow_edge
Exterior Semi-Tech
1
09-10-2008 01:47 PM