|
Hurst shifter (CO)
2 Attachment(s)
Was installed in my 04 for about a month, before removing due to leaking issues. I have been really busy with work and getting ready for college next year and just haven't had much time to address the problem. I could also use the money for college.
I am asking $170, I bought it for $220 on summit. I can meet up to 20 miles from Colorado Springs. I am also willing to ship as long as a means of payment is discussed. The boot has already been cut, to fit beneath cup holders. Attached picture shows everything that will be sold. |
I wish I had the money for this
|
2 Attachment(s)
Originally Posted by EStrauch12
(Post 1962424)
Was installed in my 04 for about a month, before removing due to leaking issues. I have been really busy with work and getting ready for college next year and just haven't had much time to address the problem. I could also use the money for college.
I am asking $170, I bought it for $220 on summit. I can meet up to 20 miles from Colorado Springs. I am also willing to ship as long as a means of payment is discussed. The boot has already been cut, to fit beneath cup holders. Attached picture shows everything that will be sold. |
Originally Posted by idigchoppers
(Post 1963226)
I have a really big favor to ask if you would not mind? I have a complete shifter EXCEPT for the mounting plate that bolts to the transmission. It is in the center of your photo. I would like to make one, but up till now I have been unable to get the proper dimensions. If it is not to much trouble could you measure your plate for me. I have uploaded a photo to show what dimensions I need. Thank you VERY MUCH!
|
Originally Posted by EStrauch12
(Post 1963362)
I could do that do you. I will have it posted by the end of the weekend I that's okay, I am busy with school this week. Also I don't have a dial caliper so my measurements may be off very slighty. But otherwise I have no problem doing that for you.
|
I have the exact same problem, got the shifter without a mounting plate and Hurst will not sell just the plate. I wish you was closer I would let you use my digital calliper. Hope to get some measurements and get a shop to mill it out for me out of 6061 Aluminum.
|
Hurst Mounting Plate DImensions:
TOP VIEW A: 7.5 cm 3 in B: 3.5 cm 1 3/8 in BOTTOM VIEW B 3.5 cm 1 3/8 in (same measurement as top view B) C 4 cm 1 9/16 in SIDE VIEW D .6 cm 1/4 in E 1 cm 3/8 in I took these measurements as precisely as possible with out the use of a digital caliper. Let me know if you have any further questions. Good luck! |
Originally Posted by EStrauch12
(Post 1965179)
Hurst Mounting Plate DImensions:
TOP VIEW A: 7.5 cm 3 in B: 3.5 cm 1 3/8 in BOTTOM VIEW B 3.5 cm 1 3/8 in (same measurement as top view B) C 4 cm 1 9/16 in SIDE VIEW D .6 cm 1/4 in E 1 cm 3/8 in I took these measurements as precisely as possible with out the use of a digital caliper. Let me know if you have any further questions. Good luck! Did you sell your shifter yet? You shouldn't have any problem selling it. They are quite popular. |
i might be interested.. lemme think about it.
|
pm sent
|
| All times are GMT -6. The time now is 02:11 PM. |
© 2024 MH Sub I, LLC dba Internet Brands