cutting up a 99 cab and 00 frame WV
 

Nothing specific for sale but either this evening or tommorrow evening I am going to cut up this cab and frame...anybody need anything? Be advised it may not be worth it to ship a cab corner or entire front suspension.
Attachment 146969Attachment 146970Attachment 146971

you happen to have a front cross member lying around?

do you have the intermediate shaft betweenthe firewall and steering wheel?

2wd yes 4wd cut in half

yes..2 I think

the 2wd will fit on a 4wd right? and if you happen to come across one please let me know.

Depends on which crossmember. The front one is different because of the coil springs. I think the trans crossmember is different also but will have to check. The rears are the same.

I took pics of the shaft, I'll post after I shower. I was weedeating and I'm covered with green crap!

hey john hows the rack/pinion on those frames? and also you got any good p/s pumps? and a spare 4.0 alt laying around? Also a Pass side bumper bracket the one that holds it up(its kinda under the fender) If that makes sense, i can take a picture of what im talking about.

dumb question.... did some 98s come with coil springs and some not?

2wds did, i don't *think?* they have tbar 2wd's in that gen.

you wouldnt happen to have a fog light valance for a 98-00 would you john? i tryed to pm you but your box is full

I think the racks good but somebody pmed me about the rack and mount for a 3rd gen lowered truck, I'll let you know. I do have another rack but we stole the inner tie rod out of it. I have a pump but its a 3.0, no alternators right now. you mean the long braket that goes towards the outside of the bumper, if so yes. send me a pic to be sure.

2wd coil 4wd bars

your right no 2wd with bars til 2001 edges

sorry no good 98-00 valances.

Do you have any rear leaf spring hangers?

Sorry no hangers.

John this might sound stupid but if you could cut me off the cab mounts it would be cool. my buddy with that s-10 his are all rusted out and he could just weld that to the top of his. like i just need the donut shaped part of it.

ok np

infact if you could just get me as much of the mounts as possible

he needs the cross member that the tow hooks mount too

Not to clutter your thread, but that is incorrect. The Ranger Trailhead edition was a rare package, but was the equivalent of an Edge, in a 4th gen Ranger. They had torsion bar front suspension and were only 2wd. I believe they may have only been made in 2000.

I will have to look but I don't think I have one


Good to know but I have never seen one.

Update...Attachment 146726Attachment 146727Attachment 146728Attachment 146729

Now John i know theres no way u used our jerry rigged saw for that

No I used the sawzall...lol quick work of that cab!

Its bout tiem you got that out of your garage lol now you have more room! Yeah!

you should see my garage...its a mess! I have parts everywhere and you can barely walk through it...lol