Checking Interest: 93 reg cab w/mustang dash NC
Checking Interest: 93 reg cab w/mustang dash NC
I think it may be time to part ways with my 93. So I am putting this out as a feeler to get some ideas if anyone would even be interested and if so, what it would even be worth. anyways, here is the info.
93 2wd reg cab short bed (fleetside) xlt. lowered 5" (square beams and progressive rate coils) up front, 4 out back (explorer axle). engine is a 4.0 w/5speed auto behind it, from a 97 ranger, 115k, super chip. as stated before, explorer axle (disk) with 3.55 l/s (may be 3.73, can't recall for sure). rear springs are from a 97 ext cab. 98-00 front clip has been started. have fenders, hood, grill, header panel, and core support. needs lights, bumper, and misc fasteners. core support needs welded in. shaved handles, tails, welded tailgate. interior has an 03 cobra dash and console. dash is mounted, column is mounted. console still needs to be mounted along with door panels fabricated. have power window regulators, just not installed. have the mustang floor shifter as well. sliding rear window.
still needs hvac, the wiring finished (have complete 97 interior/under hood wiring harness to use), exhaust, paint and assembly. the tailgate is starting to crack, so some body work is needed.










again, this is just a feeler. I may even consider parting it out, but not at this time. would rather see it go to someone and finished over being scrapped. feel free to ask questions. have NC title.
93 2wd reg cab short bed (fleetside) xlt. lowered 5" (square beams and progressive rate coils) up front, 4 out back (explorer axle). engine is a 4.0 w/5speed auto behind it, from a 97 ranger, 115k, super chip. as stated before, explorer axle (disk) with 3.55 l/s (may be 3.73, can't recall for sure). rear springs are from a 97 ext cab. 98-00 front clip has been started. have fenders, hood, grill, header panel, and core support. needs lights, bumper, and misc fasteners. core support needs welded in. shaved handles, tails, welded tailgate. interior has an 03 cobra dash and console. dash is mounted, column is mounted. console still needs to be mounted along with door panels fabricated. have power window regulators, just not installed. have the mustang floor shifter as well. sliding rear window.
still needs hvac, the wiring finished (have complete 97 interior/under hood wiring harness to use), exhaust, paint and assembly. the tailgate is starting to crack, so some body work is needed.










again, this is just a feeler. I may even consider parting it out, but not at this time. would rather see it go to someone and finished over being scrapped. feel free to ask questions. have NC title.
Thread
Thread Starter
Forum
Replies
Last Post
Checking Interest: CHECKING INTEREST! Mustang Dash Modded NC
drppdyllwrngr
OLD - Interior, Exterior, Electrical, & Misc.
2
Jan 26, 2013 05:10 PM
TrePaul86
OLD - Interior, Exterior, Electrical, & Misc.
4
May 21, 2009 12:40 AM
doc
General Ford Ranger Discussion
6
Nov 12, 2006 08:57 PM






