i have the t bars cranked on my 08 ranger but would like to go more my plan is to max them out them turn them back a turn. my question is how do you know when there maxed do the bolts stop turning or is there another way

 

crank the drivers side all the way in ( = maxed) match passenger side in height. DONE.

 

height being measured from what

 

Max them out and you'll be replacing ball joints shortly after. Well hopefully you get an alignment after the crank, but after that the BJ's will go on you. Plan to replace them with MOOG's.

 

from the ground to the top of the fender

 

so the torsion bolt will stop when maxxed out right

 

the drivers side will the passengers side wont. when maxed and sitting level the drivers side will be all the way in and the passenger side will still not be all the way in.

 

ok perfect thanks guys!!

 

expect a rough ride maxin your t-bars too but like said above just max your drivers side measure from the ground to fender and crank your pass side to the same height and youre done